CNC cut 1/8” thick body mount steel plates (pair) lightly coated in oil. Use these when performing a Body Mount or Cab mount chop for additional tire clearance. Typically this process is required to run most tire sizes over stock on Tacoma, 4-runner and FJ Cruisers.
Currently works on the following vehicles:
2005 to current Toyota Tacoma (2nd and 3rd Generation)
2010+ Toyota 4Runner (5th Generation)
2004 to 2009 Toyota 4Runner (4th Generation)
Toyota FJ Cruiser
(may be more to come)
Ground shipping to continental US. Additional shipping costs may be required for shipping to Alaska or Hawaii. Please call before ordering if you are in these locations for accurate shipping quotes.
Fits 2" Receivers - Innovative block design has a working load limit of 13,000 lbs*. Fits all standard 2 inch receivers and 3/4 screw pin shackle rings. Shackle Block includes 2 pin mounting points for vertical block configuration and 1 pin mount hole for horizontal block configuration. *This assembly includes a shackle rated at 9,500 lbs. Do not exceed the lowest Working Load Limit (WLL) of any component (ex: vehicle, hitch receiver, etc)
Complete Assembly - Includes hitch pin and D-ring shackle. Installs in seconds.
Made in U.S.A - Limited Lifetime Warranty. Agency 6 Shackle Blocks are designed and manufactured in house with US Certified 6061 T6 CNC machined aluminum.
Black Powder Coated Shackle Block - Stays looking great thanks to UV and abrasion resistant coating.
3/4" D-Ring Shackle, 4 3/4 ton WLL
5/8" Hitch Pin w/ Clip
2010+ 4Runner Rear Bumper Hinge Assembly Replacement and Hardware Kit
This compact vehicle mounted compressor has been designed to do everything! Activate your ARB Air Locking Differentials, air up a 35" tire in less than a minute and run air tools. This 100% duty cycle, 6.16 CFM compressor is built to support all of your compressed air needs. Includes a full wiring harness, air locker solenoid terminals, OE-grade compressor isolating switch, mounting hardware and instructions.
Pneumatic supply and electrical control for ARB Air Locker (Air Locker Manifold Kit #171503 required)
Rapid inflation of small, medium and large tires
100% duty cycle
Sealed for moisture and dust resistance
Air tools rated up to 85LPM [3CFM] @ 6Bar [90PSI] continuous supply
Air tools rated higher than 85LPM [3CFM] @ 6Bar [90PSI] using an optional air tank suitable to the run time requirements
Fully assembled and tested air compressor (12V)
Complete wiring loom with Air Locker solenoid plug-in terminals